Harbor Freight Tools Stove 91614 User Manual

TWO BURNER  
PROPANE STOVE  
91614  
ASSEMBLY & OPERATING INSTRUCTIONS  
FORYOUR SAFETY  
If you smell gas:  
FORYOUR SAFETY  
Do not store or use gasoline or other flam-  
mable vapors and liquids in the vicinity of this  
or any other appliance.  
1. Check that the bottle is tightly screwed to  
the regulator.  
2. Shut off gas to the appliance.  
3. Extinguish any open flame.  
WARNING: Improper installation, adjustment,  
alteration, service, or maintenance can cause  
injury or property damage. Read the installa-  
tion, operating, and maintenance instructions  
thoroughly before installing or servicing this  
equipment.  
4. If odor continues, properly dispose of the  
propane bottle and use another.  
WARNING: For Outdoor Use Only.  
®
3491 Mission Oaks Blvd., Camarillo, CA 93011  
©
®
Copyright 2004 by Harbor FreightTools . All rights reserved. No portion of this manual  
or any artwork contained herein may be reproduced in any shape or form without the express  
written consent of Harbor Freight Tools.  
For technical questions and replacement parts, please call 1-800-444-3353  
 
Frequent cleaning may be necessary. It is imperative that the Fuel Inlet, the burners, and valves  
of the Stove be kept clean.  
Carbon Monoxide Inhalation Hazard  
3.  
The Propane Stove must never be used indoors, in a house, or any other sealed  
structure. Carbon monoxide is produced during operation and is DEADLY in a  
closed environment. Early signs of carbon Monoxide poisoning resemble the flu, with  
headaches, dizziness, or nausea.If you have these signs, the heater may not be working  
properly or is improperly vented, get fresh air immediately.  
Risk of Fire and/or Explosion  
4.  
5.  
Do not store extra propane tanks in the vicinity of the Propane Stove or any other  
appliance.  
If gas is smelled during operation, immediately turn the Burner Control Knob (8)  
to OFF, and close the valve on the propane tank. Propane gas is odorless. An odor-  
making agent is added to propane/LP gas to enable you to smell the gas if it may be  
leaking.  
6.  
7.  
If the Propane Stove shuts off during operation, turn the Control Knob to OFF,  
check the amount of fuel in the tank and wait 5 minutes for the gas to clear before  
restarting. If it continues to shut off during operation, have it serviced by a qualified  
technician.  
Never place the Propane Stove within 10 feet of flammable objects such as wood,  
trees, overhangs, and umbrellas.  
Risk of Burns-Propane Stove Gets Very Hot During Use.  
8.  
Do not attempt to move the Propane Stove while it is in operation. Turn it off and  
wait one-half hour until it cools down before moving.  
9.  
Do not touch the Burner and Fuel Jet Assembly while the Propane Stove is lit.  
Before servicing, wait one-half hour for the Propane Stove to cool down.  
10.  
11.  
12.  
Children and adults should be alerted to the hazards of high surface temperatures  
and should stay away to avoid burns or clothing ignition.  
Young children should be carefully supervised when they are in the area of the  
Stove.  
Clothing or other flammable materials should not be hung from the Stove,or placed  
on or near the Stove.  
13. Turn OFF the stove immediately and have a qualified technician check the stove if any of  
the following exists:  
a)  
b)  
c)  
The smell of propane gas in conjunction with extreme yellow tipping of the burner flames.  
The stove does not reach temperature.  
The burner makes a popping noise during use. (A slight popping noise is normal when the  
burner is extinguished).  
14. If the burner is not operating normally, shut off the propane gas before checking to see if  
anything is obstructing the gas flow. The lit burner should operate with a blue flame, with a  
small yellow tip.  
15. WARNING: This product contains or, when used, produces a chemical known to the State of  
California to cause cancer and birth defects or other reproductive harm. (California Health &  
Safety Code 25249.5, et seq.)  
16. This Stove must be used with an appropriate LP gas regulator (included).  
SKU 91614  
For technical questions, please call 1-800-444-3353.  
Page 3  
 
Warning:  
The warnings, cautions, and instructions discussed in this instruction manual  
cannot cover all possible conditions and situations that may occur. It must be  
understood by the operator that common sense and caution are factors which  
cannot be built into this product, but must be supplied by the operator.  
Assembly and Operation  
Your Two Burner Propane Stove will require some simple assembly as described in the following  
steps. To assist you with assembly and operation please refer to the Operational Figures as well as  
the Assembly Diagram and Parts List located on the last pages of this manual.  
1.  
2.  
Pull the Latches (6) up from the top and around to the bottom of the Stove-see Figure 1.  
Make certain that the stove is on a flat, level surface capable of supporting the weight of the  
Stove and the items to be heated. Raise the Cover (1), then raise the Side Shields (2) on  
both sides of the Stove. Insert the tabs on the Cover (1) through the hole in the side of the  
Side Shields (2). Raise each Side Shield (2) completely into place so that the tab locks into  
place at the end of the groove.  
Figure 1  
Burner and Fuel  
Jet Assembly (7)  
Side Shield (2)  
Latch (6)  
Burner Control Knob (8)  
Tube and Valve Adapter (4)  
Figure 2  
Attach to propane  
canister (not included)  
Thread onto  
Tube and Valve  
Stove  
Adapter (4)  
3.  
4.  
5.  
Thread the Tube and Valve Adapter Assembly (4) onto the Stove-see Figure 2. Tighten  
securely by hand or using a wrench.  
Make certain that both the Burner Control Knobs (8) are in the OFF position before attaching  
the propane canister (not included).  
Attach the other end of the Tube and Valve Adapter (4) to the propane canister (not  
included).  
SKU 91614  
For technical questions, please call 1-800-444-3353.  
Page 4  
 
6.  
7.  
To light the Burner and Fuel Jet Assembly (7), place a lit match next to the Burner and Fuel  
Jet Assembly (7). Slightly turn the Burner Control Knob (8).  
Slightly turn the Burner Control Knob (8) counterclockwise for the Burner and Fuel Jet  
Assembly that (7) you wish to light. Remove the match from the Burner and Fuel Jet  
Assembly (7) once the flame is ignited.  
Increasing and Decreasing Heat/Flame to Burner Assembly  
1.  
2.  
3.  
4.  
Turning the Burner Control Knob (8) counterclockwise will increase the flow of gas to the  
Burner Assembly and Fuel Jet (7). This will increase the size of the flame.  
Turning the Burner Control Knob (8) clockwise will decrease the flow of gas to the Burner  
Assembly and Fuel Jet (7). This will decrease the size of the flame.  
To completely turn off the propane gas flow, turn the Burner Control Knob (8) completely  
clockwise.  
If the Fuel Jet (8) gets blocked, it will need to be serviced by a qualified technician before  
further use. Only a qualified service technician should perform the following steps:  
(a) Remove the Tube and Valve Adapter (4). (b) Disconnect the Burner and Fuel Jet  
Assembly (7) from the Stove. (c) Clean it with a mild detergent. (d) Reconnect the Burner  
and Fuel Jet Assembly (7). (e) Replace the Tube and Valve Adapter (4).  
Storing the Two Burner Propane Stove for Travel  
Before folding up your Propane Stove for travel, make certain that it has completely cooled  
off after use.  
a)  
Make certain that all knobs are in the OFF position and all nearby flames and  
sources of ignition are extinguished. Remove the Tube and Valve Adapter (4) from  
the propane gas canister.  
b)  
c)  
d)  
e)  
Unscrew the Tube and Valve Adapter (4) from the Stove.  
Slide the tabs on the Cover (1) out from each Side Shield (2).  
Fold down each Side Shield (2), and fold down the Cover (1).  
Flip the Latches (6) around to the top so that they hold the Cover closed.  
Unpacking  
When unpacking your Two Burner Propane Stove, check to make sure the following parts  
are included. If any parts are missing or broken, please call HARBOR FREIGHTTOOLS at  
1-800-444-3353.  
Part # Description  
Quantity Part # Description  
Quantity  
1
2
3
4
Cover  
Side Shield  
Grid  
1
2
1
5
6
7
8
Fuel Inlet and Air Control  
Latch  
Burner and Fuel Jet Assembly  
Burner Control Knob  
2
2
2
2
Tube and Valve Adapter 1  
Note: Some parts are listed and shown for illustration purposes only and are not available  
individually as replacement parts.  
SKU 91614  
For technical questions, please call 1-800-444-3353.  
Page 5  
 
Assembly Diagram  
PLEASE READ THE FOLLOWING CAREFULLY  
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN THIS MANUAL  
AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER NOR DISTRIBUTOR MAKES ANY  
REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO  
MAKE ANY REPAIRS TO THE PRODUCT OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS  
OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY STATES THAT  
ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED  
TECHNICIANS AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING  
OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR  
ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.  
SKU 91614  
For technical questions, please call 1-800-444-3353.  
Page 6  
 

Graco Inc Pressure Washer 308 532 User Manual
Haier Refrigerator HDE10WNA User Manual
HannsG Computer Monitor JG191A User Manual
HP Hewlett Packard Tablet Accessory 344524 001 User Manual
Hubbell Switch LXi 1900 User Manual
Hunter Fan Outdoor Ceiling Fan 41736 User Manual
Husky Pressure Washer 1750 US User Manual
Husqvarna Chainsaw 268 XP User Manual
iHome Clock IP16 User Manual
Image Home Gym IMBE40890 User Manual