Tripp Lite Power Supply 93 2268_EN User Manual

Owner's Manual  
LINE  
CONDITIONERS  
1111 W. 35th Street  
Chicago, IL 60609 USA  
Customer Support:  
+1(773) 869-1234  
(220/240V-50/60 Hz )  
ESPAÑOL: p. 6  
FRANÇAIS: p. 11  
DEUTSCH: p.16  
Safety:  
p. 2  
Quick Installation: p. 3  
Basic Operation:  
Service:  
p. 4  
p. 5  
Warranty:  
p. 5  
Copyright © 2004 Tripp Lite. All rights reserved.  
 
Quick Installation—220/240V-50/60 Hz  
Connect your computer  
1
or electronics to the Line  
Conditioner, and the  
Line Conditioner to an  
electrical outlet.  
A. Exchange the Line Conditioner's cord with  
your equipment's cord. Connect the Line  
Conditioner cord's male plug into a Line  
Conditioner receptacle. Connect its female  
plug into the equipment's male input.  
B. Connect the equipment cord's male plug  
into a wall outlet. Connect its female plug into  
the line conditioner's male input.  
Connect additional  
2
equipment to the Line  
Conditioner in the same  
manner.  
Additional cords and receptacle adapters are  
available to accommodate most outlet  
configurations.  
Turn on your Line  
Conditioner's power  
switch.  
3
Note: (select models) Source Voltage  
Matching Switch  
Set the source voltage matching switch to  
either 208, 220 or 240 volts to match the  
input voltage being used.  
3
 
Basic Operation  
Indicator Lights  
All indicator light descriptions apply when the Line Conditioner is plugged  
into a wall outlet and turned on. (Available on select models only.)  
A green "NORM" light will turn ON whenever your Line Conditioner is plugged in  
and receiving nominal AC line voltage.  
Yellow lights labelled "LOW" (or "BOOST") and "HIGH" (or "TRIM") will turn  
ON when incoming voltage is above or below nominal AC line voltage.  
Red lights labelled "VERY HIGH" or "VERY LOW" will turn ON when incoming  
voltage is substantially above or below nominal AC line voltage.  
A green "LINE OK" light will turn ON when AC power is present and no wiring  
faults are detected. When this light is illuminated, AC power is acceptable for  
connected equipment.  
A red "LINE FAULT" light will turn ON to indicate a wiring fault has been  
detected. The condition should be investigated and repaired by a qualified technician  
as soon as possible. A loose wall outlet may cause this light to come ON. Your Line  
Conditioner will identify most common wiring faults (but not necessarily every  
possible type of fault).  
Other Features  
AC Receptacles: The receptacles provide your connected equipment with  
AC line power during normal operation. They adjust incoming voltage to pro-  
vide equipment with nominal 220/240V power. The receptacles also protect  
your equipment against damaging surges and line noise, eliminating the need  
IEC-320-C13  
for external surge suppression.  
(220/240V)  
Note: As the Line Conditioner corrects fluctuating input voltages, the unit will  
make a gentle clicking sound. The frequency of the clicking will depend on the  
quality of the utility power in your particular area. The clicking is normal and  
indicates the Line Conditioner is compensating for fluctuating input voltages as  
NEMA 5-15R*  
(220/240V)  
described in this manual.  
* Available on select models.  
NEMA 6-15R*  
(220/240V)  
Circuit Breaker (Available on select models): If the rated capacity of  
the Line Conditioner is exceeded at any time, the circuit breaker will open  
(trip). Remove the overload and let the circuit breaker cool for one minute.  
Reset the circuit breaker by pushing in the plunger.  
4
 
Service  
If returning your Line Conditioner to Tripp Lite or an authorized Tripp Lite service center,  
please carefully pack the it using the ORIGINAL PACKING MATERIAL that came with the  
unit. Enclose a letter describing the symptoms of the problem. If the Line Conditioner is  
within the 2 year warranty period, enclose a copy of your sales receipt.  
2-Year Limited Warranty  
TRIPP LITE warrants its products to be free from defects in materials and workmanship for a period of two years from  
the date of initial purchase. TRIPP LITE’s obligation under this warranty is limited to repairing or replacing (at its sole  
option) any such defective products. To obtain service under this warranty, you must obtain a Returned Material  
Authorization (RMA) number from TRIPP LITE or an authorized TRIPP LITE service center. Products must be  
returned to TRIPP LITE or an authorized TRIPP LITE service center with transportation charges prepaid and must be  
accompanied by a brief description of the problem encountered and proof of date and place of purchase. This warran-  
ty does not apply to equipment which has been damaged by accident, negligence or misapplication or has been  
altered or modified in any way. This warranty applies only to the original purchaser who must have properly registered  
the product within 10 days of purchase.  
EXCEPT AS PROVIDED HEREIN, TRIPP LITE MAKES NO WARRANTIES, EXPRESS OR IMPLIED, INCLUDING  
WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. Some states do not permit  
limitation or exclusion of implied warranties; therefore, the aforesaid limitation(s) or exclusion(s) may not apply to the  
purchaser.  
EXCEPT AS PROVIDED ABOVE, IN NO EVENT WILL TRIPP LITE BE LIABLE FOR DIRECT, INDIRECT, SPECIAL,  
INCIDENTAL OR CONSEQUENTIAL DAMAGES ARISING OUT OF THE USE OF THIS PRODUCT, EVEN IF  
ADVISED OF THE POSSIBILITY OF SUCH DAMAGE. Specifically, TRIPP LITE is not liable for any costs, such as  
lost profits or revenue, loss of equipment, loss of use of equipment, loss of software, loss of data, costs of substitutes,  
claims by third parties, or otherwise.  
The policy of TRIPP LITE is one of continuous improvement. Specifications are subject to change without notice.  
Regulatory Compliance Identification Numbers  
Select models: For the purpose of regulatory compliance certifications and identification, your Tripp Lite product may  
have been assigned a unique series number. The series number can be found on the product nameplate label, along  
with all required approval markings and information. When requesting compliance information for this product, always  
refer to the series number. The series number should not be confused with the marking name or model number of the  
product.  
5
 
1111 W. 35th Street, Chicago, IL 60609 USA  
773.869.1234 (USA) • 773.869.1212 (International)  
200407139 93-2268_EN  
 

Texas Instruments Switch TNETX4090 User Manual
Thermo Products Air Conditioner 30 User Manual
Topcom Telephone COCOON 300 User Manual
Toro Sprinkler FLX34 User Manual
Toshiba DVD Player SD K740SU User Manual
Toshiba DVD Recorder DVR620KU User Manual
TP Link Wireless Office Headset TL SM221A User Manual
Uniden Cordless Telephone DCX520 User Manual
Univex Lawn Mower Accessory 358792400 User Manual
Volvo Automobile S40 User Manual