Transition Networks TV Converter Box FD CD 01 User Manual

MEDIA CONVERTER TECHNICAL SPECIFICATIONS  
Standards  
ANSI X3T12 FDDI  
Minneapolis, MN 55344 USA  
Case dimensions  
Environment  
4.7" x 3.0" x 1.0"  
(119mm x 76mm x 25mm)  
FDDI/CDDI Media Converters  
Temperature:  
Humidity  
Altitude  
0-40°C (32° to 104° F )  
10-90%, non condensing  
0-10,000 feet  
FD-CD-01, FD-CD-01(SM)  
USER’S GUIDE  
Warranty  
Lifetime  
Power Supply Requirements Replace power supply with only the equivalent input  
rating (see below) and output rating (regulated 12VDC @1.5 A).  
The TRANSITION Networks Ethernet™ CDDI to FDDI media converters connect CDDI  
unshielded twisted pair cable to FDDI multimode OR to FDDI singlemode fiber-optic  
cable. Media converter models are selected according to the fiber mode required at the  
site. Both multimode fiber (FD-CD-01) and singlemode fiber (FD-CD-01(SM)) media  
converters use a standard SC connector. Both media converters function in half-duplex  
mode or, when connected to devices capable of full-duplex connectivity, in full-duplex  
mode. An MDI/MDI-X switch allows straight-through twisted-pair cable to be used for  
crossover CDDI connections.  
TN PN  
3507  
3342  
3340  
3346  
3511  
3537  
Requirement  
Location  
United Kingdom  
Europe  
USA/Canada/Mexico  
Japan  
Australia  
240 volts, 50 hertz  
230 volts, 50 hertz  
120 volts, 60 hertz  
100 volts, 50-60 hertz  
240 volts, 50 hertz  
(with power cord: 3522)  
South Africa  
M D I - X  
M D I  
FD-CD-01  
UTP  
NOTE: This product also can be powered by the Transition Networks E-MCR series media  
converter rack.  
Provides an RJ-45 twisted pair CDDI  
connector and an RX (receive) and TX  
(transmit) SC FDDI connector to multimode  
fiber-optic cable.  
CAUTION: RJ connectors are NOT INTENDED FOR CONNECTION TO THE  
PUBLIC TELEPHONE NETWORK. Failure to observe this caution could result in  
damage to the public telephone network.  
Multimode Fiber  
UTP  
FD-CD-01  
M D I - X  
M D I  
FD-CD-01(SM)  
Der Anschluss dieses Gerätes an ein öffentlickes Telekommunikationsnetz in den EG-Mitgliedstaaten  
verstösst gegen die jeweligen einzelstaatlichen Gesetze zur Anwendung der Richtlinie 91/263/EWG zur  
Angleichung der Rechtsvorschriften der Mitgliedstaaten über Telekommunikationsendeinrichtungen  
einschliesslich der gegenseitigen Anerkennung ihrer Konformität.  
Provides an RJ-45 twisted pair CDDI  
connector and an RX (receive) and TX  
(transmit) SC FDDI connector to singlemode  
fiber-optic cable.  
Singlemode Fiber  
Compliance Information  
UL Listed  
FD-CD-01(SM)  
C-UL Listed (Canada)  
CISPR/EN55022 Class B  
Status LEDs on the connector side of the media converters provide the following  
information:  
FCC Regulations  
Power Illuminated green LED indicates connection to  
This equipment has been tested and found to comply with the limits for a class B digital device, pursuant  
to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful  
interference when the equipment is operated in a commercial environment. This equipment generates,  
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the  
instruction manual, may cause harmful interference to radio communications. Operation of this  
equipment in a residential area is likely to cause harmful interference, in which case the user will be  
required to correct the interference at the user’s own expense.  
external AC power.  
CDDI Connector  
SDF  
SDC  
RXC  
RXF  
Signal Detect/Fiber: Steady green LED  
indicates fiber port is connected to device.  
Signal Detect/Copper: Steady green LED  
indicates RJ-45 port is connected to device.  
Receive/Copper: Flashing green LED indicates  
packets are seen on RJ-45 port.  
Power  
TX  
RX  
SDF  
SDC  
RXC  
RXF  
UTP/ST
Fiber  
Power  
FDDI Connector  
SDF  
SDC  
Canadian Regulations  
RXC  
RXF  
This digital apparatus does not exceed the Class B limits for radio noise for digital apparatus set out on  
the radio interference regulations of the Canadian Department of Communications.  
Receive/Fiber: Flashing green LED indicates  
packets are seen on fiber port.  
Copyright Restrictions  
© 1997 TRANSITION Networks.  
All rights reserved. No part of this work may be reproduced or used in any form or by any means –  
graphic, electronic, or mechanical – without written permission from TRANSITION Networks.  
NOTE: Since the FDDI/CDDI protocol passes a “token” across the entire FDDI/CDDI  
ring, the RXC/RXF LEDs are continuously illuminated during normal operation.  
Trademark Notice  
 
All registered trademarks and trademarks are the property of their respective owners. 33025.B  

Texas Instruments Switch TMS320DM643x DMP User Manual
Toastmaster Toaster TC200030 User Manual
TP Link Network Router TR 966D User Manual
Transition Networks Home Security System E TBT MC04 User Manual
Tripp Lite Network Cables N201 010 WH User Manual
Uniden Cordless Telephone EWCI 936 User Manual
Vantec Laptop LPC 301 User Manual
Vermont Casting Indoor Fireplace DVRT41 User Manual
Vivitar Camcorder 990HD User Manual
VTech Video Game Headset IS6100 User Manual