The Swan Corporation Indoor Furnishings BS 1515 User Manual

BAR SINKS  
BS-1515  
TOOLS REQUIRED  
• Ruler  
• Drill  
• Caulk  
• Saber Saw  
(if counter top  
cutout is required)  
BS-2515  
TRACE COMPLETELY  
AROUND EDGE OF SINK  
DRAW A 1-1/2؆ RADIUS  
AT EACH CORNER  
DRILL STARTER HOLE  
INSIDE OF CUTOUT LINE  
CUT INSIDE OF LINE  
5/16Љ  
CUTOUT LINE  
1. If it is necessary to cut out  
the counter top, invert sink  
and position onto the counter  
top. Locate sink front to rear  
and so that the bowl will not  
interfere with the cabinets  
below. Trace a pencil line  
around the outside edge of  
the sink and remove the sink  
from the counter top.  
2. Measure in 5/16Љ from the  
initial sink outline and draw a  
second line inside the first.  
Draw a 1-1/2Љ radius at each  
corner. This second interior  
line will be your cutout line.  
3. Drill starter hole inside of  
cutout line.  
4. Using a saber saw, cut  
inside of cutout line. Trial fit  
sink to check proper fit.  
Check Cutout  
Line Measurements  
Model  
BS-1515  
BS-2515  
Width  
14-3/8Љ  
24-3/8Љ  
Depth  
14-3/8Љ  
14-3/8Љ  
Measure the cutout or the  
pre-cut opening to be sure it  
conforms to the sizes listed.  
OWNER’S MANUAL  
MODEL NOS.  
BS-1515  
CAUTION:  
Read ALL instructions carefully  
BEFORE starting your installation.  
Save this manual for future reference.  
Installation  
Care and  
Cleaning  
BS-2515  
 

Teledyne Inflatable Bouncy Toy 6400E User Manual
TP Link Network Router TL WR542G User Manual
Trane Air Compressor TRG TRC004 EN User Manual
TRENDnet Switch S55Eplus User Manual
Vanguard Heating Indoor Fireplace VSGF28NTC User Manual
Venturer Portable DVD Player PVS1262 User Manual
ViewSonic Projector PJL7211 User Manual
VocoPro Karaoke Machine AVC 800 User Manual
Weber Gas Grill 450 User Manual
Weed Eater Blower 545137215 User Manual